|
Xtremegard offers extended service contracts for the following, Motorcycle, ATV, Watercraft, and Snowmobiles.
  
Coverage "Motorcycle" & "ATV"
Covered Components
Engine
All internally lubricated parts; valve covers; intake manifolds; oil pump; reed valves; engine mounts. (Cylinder head(s); engine block/crankcase and cylinder barrels if damaged as a result of the Failure of an internally lubricated covered engine component.)
Water Pump
Impeller shaft; bearings; bushings; and housing.
Turbocharger
Internal parts; vanes; shafts; bearings, bushings, waste gate and housing if damage is caused by a Failure of any of the above covered components.
Transmission
All internally lubricated parts contained within the transmission case; gears; bearings; internal drive gears; internal selector mechanism and transmission mounts. Transmission case if damaged as a result of the Failure of an internally lubricated transmission component. (Clutch assembly and cable are not covered).
Primary Drive
All internally lubricated parts (except clutch and hub assembly) contained within the primary drive case; all gears; bearings; internal drive gears and chains; internal selector mechanism. Primary drive case if damaged as a result of the Failure of a covered primary drive component.
Drive Axle Assembly (Shaft driven motorcycles and ATV’s)
Differential housing; transaxle housing; final drive housing; all internally lubricated parts of the foregoing; axle shafts; constant velocity joints; universal points; drive shafts; locking hubs; hub bearings; locking rings; supports; retainers and bearings.
Steering
Upper and lower steering stem bearings and bushing axle; steering stem; handle bar; steering stem nut, rod ends. Steering stem shaft if damaged as a result of the Failure of a covered component.
Front and Rear Suspension
All internally lubricated parts contained within the front fork tubes and front hub; swing arm bearings or bushings; front and rear wheel bearings, frame swing arm; upper and lower control arms; ball joints; king pins; bushings and spindle. Front fork tubes and front hub if damaged as a result of the Failure of a covered suspension component.
Brake
Brake backing plates; brake hubs; calipers; master cylinder assembly; hydraulic lines and fittings; drum brake actuating cam; secured hardware.
Electrical
Alternator; starter assembly; manually operated switches; cooling fan motor; wiring harness; ignition coil(s); rectifier, stator assembly; rotor assembly; CDI control box/electronic ignition control module; magneto; electronic fuel injection control module and voltage regulator.
Gauges
All factory instrumentation (mechanical and electronic) and electronic instrument sensors. (Light bulbs are not covered).
Fuel System
Petcock; fuel lines and fittings; fuel pump and housing; diaphragms; springs; valves and actuating lever.
Touring Bikes
Digital dash components; control cables; factory installed sound system (Speakers are not covered); fairing hardware; brackets, switches, covers, latches and hinges; saddlebar/travel trunk latches, hinges and mounting hardware.
Seals and Gaskets (New Motorcycles Only)
Seals and gaskets are covered as needed, when used in conjunction with the replacement of a failed covered component.
For more information, please see our Comprehensive Brochure, American V-Twin Brochure and Powersports Brochure.
Coverage "Watercraft"
Covered Components
Engine
All internally lubricated parts including: pistons, rings, pins, crankshaft and main bearings, connecting rods and rod bearings, reed valves and reed blocks, cylinder heads, crankcase, flywheel. Cylinder block if damaged as a result of the Failure of an internally lubricated engine component.
Lower Unit
Gearcase head; bearing oil retainer; gearcase assembly; driveshaft and upper bearing; shift rod and cover assembly; lower pinion bearing; forward and/or pinion gear; reverse gear; shift fork; gearcase and/or propeller shaft if damaged as a result of the Failure of a lubricated covered component.
Lubricating System
Oil pump; oil injection drive gear and/or shaft; oil tank; oil cap; oil level sensor; oil level warning horn; oil lines; check valve; complete oil injection metering system.
Steering
Steering control helm assembly; steering gate; rudder nozzle (excluding cables); steering bracket and bushing; swivel bracket bearing; control rack and yoke assembly; power steering pump; power cylinder assembly; steering wheel and coupling; steering cable.
Jet Drive/Pump System
All internally lubricated parts in the pump housing; housing; bearings; impeller bushings.
Controls
Neutral start switch assembly; starter/choke primer switch; starter/stop button; throttle control handle; throttle cam lever; throttle and shift cable; shift interrupter switch; tilt/trim switch and ignition switch (excluding key and tumbler).
Power Trim and Tilt
Spring sending unit; oil pump; relief valve; spring; O-ring; trim cylinder; tilt cylinder; manual release valve; hydraulic pump; reverse lock valve; power tilt motor; power trim motor; mounts; pivots.
Fuel System
Fuel delivery pump; fuel injection pump; fuel injector(s); fuel tank; fuel cap; petcock; flame arrestor/air silencer; fuel lines; EFI (DFI) control module.
Electrical Alternator; starter assembly; starter solenoid; voltage regulator; rectifier; ignition coil; switch box/power pack; electronic ignition module; trigger and sensor; windshield wiper motor; CDI box; all electrically operated gauges.
U-Joint Housing/Drive Line System
Drive mount and steering components; transom plate; U-joint housing; U-joint housing bearing; U-joints; drive shaft(s); bushings; bearings; flywheel; pivot pin; shift lever.
Seals and Gaskets (New Vehicles Only)
Seals and gaskets are covered as needed, when used in conjunction with the replacement of a FAILED covered component.
For more information, please see our brochure.
Coverage "Snowmobiles"
Covered Components
Engine
All internally lubricated parts including: pistons; piston rings and pins; crankshaft and main bearings; connecting rods and rod bearings; reed valves and reed blocks; rotary valves; exhaust manifold; motor mounts. Cylinder head(s), engine block and cylinder barrels if damaged as a result of the Failure of an internally lubricated engine component.
Cooling System
Water pump; cooling fan motor; fan shaft and bearings; heat exchanger and radiator.
Oil Injection
Oil injection drive gear; oil tank; oil level sensor; oil injection pump; oil injection metering system.
Fuel System
Fuel tank; choke cable(s); fuel pump; fuel injector(s) and fuel injection metering system.
Electrical (New Snowmobiles Only)
Alternator; starter assembly (electric only); manually operated switches; wiring harness; ignition coil(s); rectifier; stator assembly; rotor assembly; CDI control box/electronic ignition control module; electronic fuel injection control module and voltage regulator.
Gauges
All factory instrumentation (mechanical and electronic) and electronic instrument sensors.
Chain Case
All internally lubricated parts within the chain case including upper and lower chain sprockets; automatic and manually adjustable tensioners; roller chain; chain case; reverse gear and gearbox (excluding shifter mechanism).
Steering
Inner and outer tie rod ends; drag link/steering link ends and spindle bushings.
Brake
Hydraulic calipers; mechanical calipers; master cylinder and brake hoses.
Primary Drive
Stationary and moveable sheaves; spider; outer cap and bushings.
Secondary Drive
Stationary and moveable sheaves; cam assembly; secondary (jack) shaft and bearings.
Seals and Gaskets (New Vehicles Only)
Coverage will be extended to include seals and gaskets. Coverage on covered components.
Please see our brochure for more information.
|